Control a LED with a Button | Push Button | LED | Arduino Tutorial

Hello , Today in this video tutorial i am going to show you Step By Step
How to control led with a push button using arduino

This Electronic Project is Very Simple Easy and DIY (Do It Yourself)

――――――――――――――――――――――――――――――――――――――――――
❖ Please Subscribe / Like Facebook Page ❖
――――――――――――――――――――――――――――――――――――――――――

https://www.youtube.com/channel/UCi6ZqREHDIx2xLrCRkrRS0w

https://www.facebook.com/Circuit-DIY-122206971927665

You Will Find Full Project Description and All Useful Material Including

• Circuit Diagram / Schematic
• Hardware / Component List
• Code
• Datasheet
• Pin Configuration Etc

AT ►

Thanks for Watching It.

↪ For Any Difficulty Please Comment Below

――――――――――――――――――――――
❖ Hardware Required ❖
――――――――――――――――――――――

► Arduino Board
► USB A to B Cable
► Breadboard
► Jumper Wires
► 470 Ohm Resistor
► Push Button
► 10k Ohm Resistor
► LED

――――――――――――――――――――
❖ Circuit Diagram ❖
――――――――――――――――――――

Link ► https://www.file-up.org/7iiws63sr1xe

―――――――――
❖ Code ❖
―――――――――

Link ► https://www.file-up.org/fhg5pyu34hw0

――――――――――
❖ Steps ❖
――――――――――

STEP # 1 ( Make Push Button Connections )

► Put Resistor 10k B/w Pin1 of Push Button and Gnd of Arduino
► Pin2 of Push Button to 5V of Arduino

STEP # 2 ( Make LED Connections )

► +VE Of LED To D13 of Arduino.
► Resistor 470 B/w -VE Of LED & then Gnd of Arduino.

STEP # 3 ( Upload Code )

► Download code and upload it to Arduino Board using Arduino IDE Software
► https://www.arduino.cc/en/Main/Software

Leave a Reply

Your email address will not be published. Required fields are marked *