How to make LED Cube | LED Cube 4x4x4 | DIY Electronics | Electronics Projects

►► https://jlcpcb.com/m

This video tutorial is SPONSORED by JLCPCB.Com
They are providing a quality PCB’s for Under 2$ Only
First register from the link below &
Upload your Gerber file / Eagle design That’s it….

►► https://jlcpcb.com/m

Today in this video tutorial i am going to show you Step By Step

How to make a simple diy LED Cube 4x4x4 circuit using ardunio nano microcontroller


❖ Please Subscribe / Like Facebook Page ❖

https://www.youtube.com/channel/UCi6ZqREHDIx2xLrCRkrRS0w

https://www.facebook.com/Circuit-DIY-122206971927665

Download All Data Files

https://www.file-up.org/gbg1owpwt7da

You Will Find Full Project Description and All Useful Material Including

• Circuit Diagram / Schematic
• Hardware / Component List
• Code
• Datasheet
• Pin Configuration Etc

AT ►

Thanks for Watching It.

↪ For Any Difficulty Please Comment Below

――――――――――――――――――――――
❖ Hardware Required ❖
――――――――――――――――――――――

► PCB LED Cube
► Diffused LED any color 64x
► 100 ohm Resistor 4x
► Female Headers
► Silver Wires 40x
► Card Piece
► Arduino Nano
► Micro-B USB Cable

――――――――――
❖ Steps ❖
――――――――――

Follow All Steps Carefully from the Video Above (Recommended)

► Take a 5×5 inch card piece and make 9 square box with 1×1 inch spacing

► Drill 5mm Hole to the corner of all boxes

► Bend -ve leg of LED with the help of Screw Driver

► Mark Arrow on Card Piece and Insert all LED (-ve leg ) facing the arrow

► Connect all positive leg of 16 led’s using silver wire

► After making 4 row using similar technique connect all -ve leg of led using silver wires

► Connect L1 L2 L3 L4 To Common +Ve of Row1 Row2 Row3 Row4 Respectively

► Solder Header

► Solder Resistors

► Upload code and Power up circuit

Leave a Reply

Your email address will not be published. Required fields are marked *