How to use 5V Relay with Arduino to turn ON and OFF AC bulb | Push Button | Arduino Relay

Hello , Today in this video tutorial i am going to show you Step By Step

How to use 5V Relay with Arduino to turn ON and OFF AC bulb | Push Button | Arduino Relay

This Electronic Project is Very Simple Easy and DIY (Do It Yourself)

――――――――――――――――――――――――――――――――――――――――――
❖ Please Subscribe / Like Facebook Page ❖
――――――――――――――――――――――――――――――――――――――――――

https://www.youtube.com/channel/UCi6ZqREHDIx2xLrCRkrRS0w

https://www.facebook.com/Circuit-DIY-122206971927665

You Will Find Full Project Description and All Useful Material Including

• Circuit Diagram / Schematic
• Hardware / Component List
• Code
• Datasheet
• Pin Configuration Etc

AT ► xxxxxxxxxxxxxxxxxxxxxxxxx

Thanks for Watching It.

↪ For Any Difficulty Please Comment Below

――――――――――――――――――――――
❖ Hardware Required ❖
――――――――――――――――――――――

► Arduino Board
► USB A to B Cable
► Breadboard
► Jumper Wires
► Relay Module
► Push Button

――――――――――――――――――――
❖ Circuit Diagram ❖
――――――――――――――――――――

Link ► https://www.file-upload.com/c67aa14t97r0

―――――――――
❖ Code ❖
―――――――――

Link ► https://www.file-upload.com/6eaczjulub2o

――――――――――
❖ Steps ❖
――――――――――

STEP # 1 ( Make Relay Connections )

► VCC – To VCC of Arduino.
► GND – To GND of Arduino.
► IN – To D10 of Arduino.

STEP # 2 ( Make Push Button Connections )

► Pin1 To GND of Arduino.
► Pin2 To D2 of Arduino.

STEP # 3 ( Upload Code )

► Download code and upload it to Arduino Board using Arduino IDE Software

https://www.arduino.cc/en/Main/Software

Leave a Reply

Your email address will not be published. Required fields are marked *